EZI-LINTELS

7 Steel Building Solutions products are hot dipped galvanised to provide long life and a quality finish.

All 7 Steel Building Solutions lintels are made to meet the following standards;

  • Hot Dip Galvanised to AS/NZ 4680:2006
  • R3 Durability rating in accordance with AS/NZS 2699.3:2002
  • Available in a large range of sizes and lengths
  • Complies with masonry structures code AS3700:2002
  • Complies with structural steel code AS4100:1998
  • Easy to use and ready to install

HOT-DIPPED GALVANISED FOR DURABILITY AND LONG LIFE

INTERNAL ANGLE ROLLED TO SUIT BRICKWORK

FLAT BASE FOR EASY LAYING OF BRICKWORK

PROPPING OF LINTELS

7Steel Lintels and flat bar enable the support of masonry over openings by utilising the strength of steel in conjunction with the strength of properly laid brickwork.

Whenever brick work is being built up over a 7Steel Lintel at a faster rate than the mortar is hardening, propping of lintels is recommended to avoid any sagging, which will not effect the strength of the lintel but may look unsightly.

END BEARING AND SELECTING LINTELS

It is recommended that a minimum of 150mm on each end of span is allowed when selecting the correct lintel eg. for an opening of 1500mm, add 150m each end, therefore a 1800mm lintel will be required.

7Steel always recommend that the advice of a structural engineer is sought when using 7Steel Lintels especially when point loads occur over openings.

LINTEL RANGE

  • 100 x 100 x 6 - 900mm
  • 100 x 100 x 6 - 1200mm
  • 100 x 100 x 6 - 1500mm
  • 100 x 100 x 6 - 1800mm
  • 100 x 100 x 6 - 2100mm
  • 100 x 100 x 6 - 2400mm
  • 150 x 100 x 6 - 1800mm
  • 150 x 100 x 6 - 2100mm
  • 150 x 100 x 6 - 2400mm
  • 150 x 100 x 6 - 2700mm
  • 150 x 100 x 6 - 3000mm
  • 150 x 100 x 6 - 3300mm
  • 150 x 100 x 6 - 3600mm
  • 150 x 100 x 6 - 4000mm
DOWNLOAD BROCHURE